How To Change Headlight Bulb 2011 Suzuki Sx4

Seedling Replacement

WARNING:
• Light bulbs tin can be hot plenty to burn your finger right later being turned off. This is true especially for halogen headlight bulbs.

Replace the bulbs after they become cool enough.

• The headlight bulbs are filled with pressurized halogen gas. They can burst and injure you if they are hit or dropped. Handle them carefully.

Caution:
The oils from your skin may cause a halogen bulb to overheat and outburst when the lights are on. Grasp a new bulb with a clean cloth.

CAUTION:
Frequent replacement of a bulb indicates the demand for an inspection of the electrical system. This should exist carried out by your SUZUKI dealer.

NOTE:
If it is difficult to replace headlight bulbs or parking light bulbs due to under-hood components trust this chore to your dealer.

Heart Interior Light (if equipped)

Pull down the lens by using a plain screw driver covered with a soft cloth every bit shown.

To install it, simply push information technology dorsum in.

The bulb can be removed by simply pulling it out. When replacing the bulb, make sure that the contact springs are holding the seedling deeply.

Headlights

Open the engine hood. Remove the coupler and the condom embrace. So unhook the bulb holding jump and replace the bulb.

Other General Lights

Bulb holder

(1) Removal
(2) Installation

To remove a bulb holder from a light housing, turn the holder counterclockwise and pull it out. To install the holder, push button the holder in and turn it clockwise.

Bulb

(3) Removal
(4) Installation

At that place are ii types of bulb, "Full drinking glass type" (1) and "Glass/metal type" (ii).

To remove and install a full glass type bulb (1), but pull out or push in the bulb.

To remove a glass metal type bulb (2) from a bulb holder, push in the bulb and turn it counterclockwise. To install a new seedling, push it in and turn it clockwise.

You lot can access the individual bulb or bulb holders as follows.

Front parking light (ane)
Front end turn signal lite (2)

Front end fog low-cal (if equipped)

SX4

SX4 SEDAN

Rear combination light (tail, stop, plough signal, etc.)

SX4

SX4 SEDAN

Spot lite

License plate light

SX4

SX4 SEDAN

Baggage compartment light (SX4)

Trunk room light (SX4 SEDAN)

Loftier-mountain stop light (if equipped)

SX4

To remove a high-mounted stop light housing the following procedure: ane) Open the tailgate, and remove the nuts (one) equally shown in the illustration.

two) Close the tailgate. Remove a highmounted terminate light housing (two) from the tailgate.

3) Pushing the unguiform prongs (three) toward inside and remove the bulb holder (four).

iv) Supplant the bulbs.

To install a high-mounted finish light housing in the opposite gild of removal.

SX4 SEDAN

Meet also:

Jump Starting Instructions
Alarm: • Never effort to spring start your vehicle if the battery appears to exist frozen. Batteries in this condition may explode or rupture if spring starting is attempted. • When making ...

Brakes
Brake Fluid Check the restriction fluid level by looking at the reservoir in the engine compartment. Check that the fluid level is between the "MAX" and "MIN" lines. If the brake fluid level ...

Maintenance Schedule
The following table shows the times when yous should perform regular maintenance on your vehicle. This table shows in miles, kilometers and months when you should perform inspections, adjustments, ...

Source: https://www.suzuguide.com/suzuki-336.html

Posted by: smitharing1997.blogspot.com

Share this post